Intergas gateway for Home Assistant (built-in integration)

About

Intergas gateway is a built-in integration that connects Home Assistant to an Intergas heating gateway over the local network. It provides binary sensors for fault, burner, pump and hot water tap, sensors for signal strength and tap temperature, and climate and water heater entities. Setup happens in the UI, using the gateway host, a username and a password, and Home Assistant can discover the gateway on the network. An option for legacy setpoint handling covers older gateway models and firmware that do not update the thermostat setpoint correctly, though updates may then take a few minutes. Connection settings can be changed later without removing the entry, and new devices appear without setting it up again.

Automatic summary of Home Assistant's source code. Something wrong? Get in touch

Supports

Works locally Talks to your devices on your own network. No vendor cloud in between.
Set up in the UI Add it in Settings, Devices and services. Nothing to download.
Found by itself Home Assistant spots it on the network and offers to add it.
Adds new devices New devices show up without setting it up again.
Change settings later Its connection settings can change without removing it.
Platinum quality Home Assistant's own rating of its code and setup experience.
Updated with Home Assistant Ships and updates with every Home Assistant release.

Provides

Climate
Water heaters
Sensors

Setting it up

Home Assistant usually finds it on the network and offers to add it. It can also be added by hand under Settings, Devices and services.

Connect

HostHostname or IP address of the Intergas gateway.
PasswordThe password to log in to the gateway, is printed at the bottom of the gateway or is intergas for some older devices.
UsernameThe username to log in to the gateway. This is admin in most cases.

Set up Intergas gateway

PasswordThe password to log in to the gateway, is printed at the bottom of the gateway or is intergas for some older devices.
UsernameThe username to log in to the gateway. This is admin in most cases.

Sign in again

PasswordCorrect the gateway password.

After setup

Legacy setpoint handlingSome older gateway models with an older firmware versions might not update the thermostat setpoint and override settings correctly. Enable this option if you experience issues in updating the setpoint for your thermostat. It will use the actual setpoint of the thermostat instead of the override. As side effect is that it might take a few minutes before the setpoint is updated.

Texts from Home Assistant's source code, Apache License 2.0.