Subaru for Home Assistant (built-in integration)

About

Subaru is a built-in integration that connects Home Assistant to MySubaru Connected Services for vehicle status and remote control. It adds sensors for fuel level, range, odometer, tire pressure, and average fuel consumption, plus EV battery level, range, and time to full charge on electric models. Binary sensors report the state of doors, hood, and tailgate, along with lock status, charging, EV plug, and vehicle health. A lock entity controls the door locks, buttons start and stop the engine remotely, and an action can unlock the driver door, all doors, or the tailgate. Setup happens in the UI with the MySubaru account details, a PIN for remote commands, and a two-factor code. An optional polling setting sends a remote command to the vehicle every 2 hours to refresh data, which draws power from the 12V battery.

Automatic summary of Home Assistant's source code. Something wrong? Get in touch

Supports

Uses the vendor's cloud Needs an internet connection and an account with the vendor.
Set up in the UI Add it in Settings, Devices and services. Nothing to download.
Bronze quality Home Assistant's own rating of its code and setup experience.
Updated with Home Assistant Ships and updates with every Home Assistant release.

Provides

Locks
Sensors
Presence

Setting it up

It is added under Settings, Devices and services, with Add integration.

MySubaru Connected Services configuration

Select countryThe country where your MySubaru account is registered.
PasswordThe password for your MySubaru account.
UsernameThe email address or username for your MySubaru account.

MySubaru Connected Services configuration

PIN codeThe 4-digit PIN used for remote commands, shared by all vehicles on your MySubaru account.

MySubaru Connected Services configuration

Please select a contact method:Where Subaru should send your two-factor authentication code.

MySubaru Connected Services configuration

Validation codeThe 6-digit code sent to your selected contact method.

After setup

Enable vehicle pollingSends a remote command to the vehicle every 2 hours to refresh sensor data. Draws power from the 12V battery.

Texts from Home Assistant's source code, Apache License 2.0.

Entities

Binary sensorsTailgate, Hood, Door front left, Door front right, Door rear left, Door rear right, EV plug, Vehicle health, Charging, Lock status tailgate, Lock status front left, Lock status front right, and 26 more
ButtonsRemote start, Remote stop
LocksDoor locks
SensorsAverage fuel consumption, EV battery level, EV range, EV time to full charge, Fuel level, Odometer, Range, Recommended tire pressure front, Recommended tire pressure rear, Tire pressure front left, Tire pressure front right, Tire pressure rear left, and 2 more