Screenshots from IOT_Ninja.
No screenshots yetAre you IOT_Ninja? Add your screenshots and they show here, at the top of the page.
What it does
Runs actions when a Zooz ZEN72 Z-Wave dimmer paddle is pressed. You pick the device, then set actions for 1 to 5 taps, hold and release on the top paddle, the lower paddle and an external momentary switch. Hold actions can loop with a set delay.
Written by vulpo.app from the blueprint file by IOT_Ninja. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
What you'll pick when you import it.
- Automation ModeOptional
- Zooz ZEN72
- Top Paddle 1xOptional
- Top Paddle 2xOptional
- Top Paddle 3xOptional
- Top Paddle 4xOptional
- Top Paddle 5xOptional
- Top Paddle HoldOptional
- Loop Upper Paddle Hold Action?Optional
- Top Paddle Hold Loop DelayOptional
- Top Paddle ReleaseOptional
- Lower Paddle 1xOptional
- Lower Paddle 2xOptional
- Lower Paddle 3xOptional
- Lower Paddle 4xOptional
- Lower Paddle 5xOptional
- Bottom Paddle HoldOptional
- Loop Lower Paddle Hold ActionOptional
- Bottom Paddle Hold Loop DelayOptional
- Bottom Paddle ReleaseOptional
- External Momentary 1xOptional
- External Momentary 2xOptional
- External Momentary 3xOptional
- External Momentary 4xOptional
- External Momentary 5xOptional
- External Momentary HoldOptional
- Loop External Momentary Hold ActionOptional
- External Momentary Hold Loop DelayOptional
- External Momentary ReleaseOptional
Information
- Forum views
- 15.9k
- Likes
- 28
- Checked
- Imports cleanly
- Category
- Remotes and buttons
- Discussion
- 95 replies on the forum