Screenshots from cree8.
No screenshots yetAre you cree8? Add your screenshots and they show here, at the top of the page.
What it does
Runs your own actions when buttons on an Inovelli Red Series LZW36 fan controller are pressed over Z-Wave JS. You pick the controller, then add actions for Button A and B taps (1x to 5x) and holds, and for the C and D up and down buttons. All actions are optional.
Written by vulpo.app from the blueprint file by cree8. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
- Logbook
logbook 
Z-Wavezwave_js
What you'll pick when you import it.
- Inovelli Fan Controller
- Button A - Up/On press 1xOptional
- Button B - Down/Off press 1xOptional
- Button A - Up/On held downOptional
- Button B - Down/Off held downOptional
- Button A - Up/On press 2xOptional
- Button B - Down/Off press 2xOptional
- Button A - Up/On press 3xOptional
- Button B - Down/Off press 3xOptional
- Button A - Up/On press 4xOptional
- Button B - Down/Off press 4xOptional
- Button A - Up/On press 5xOptional
- Button B - Down/Off press 5xOptional
- Button C - Up/Increase (Top)Optional
- Button C - Down/Decrease (Top)Optional
- Button D - Up/Increase (Bottom)Optional
- Button D - Down/Decrease (Bottom)Optional
Information
- Forum views
- 4.7k
- Likes
- 12
- Checked
- Imports cleanly
- Category
- Remotes and buttons
- Discussion
- 32 replies on the forum