Screenshots from KeviinCosmos.
No screenshots yetAre you KeviinCosmos? Add your screenshots and they show here, at the top of the page.
What it does
Runs your own actions from the four buttons of a Schneider Electric Wiser FUGA wall switch connected through Zigbee2MQTT. You pick the device, then set actions for press, hold and release on each corner, plus an optional hold delay.
Written by vulpo.app from the blueprint file by KeviinCosmos. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
What you'll pick when you import it.
- Zigbee2MQTT device
- Hold delayOptional
- 1. Top Left Pressed (on_top)Optional
- 1. Top Left Held (brightness_move_up_top)Optional
- 1. Top Left Released (brightness_stop_top)Optional
- 2. Top Right Pressed (off_top)Optional
- 2. Top Right Held (brightness_move_down_top)Optional
- 2. Top Right Released (brightness_stop_top)Optional
- 3. Bottom Left Pressed (on_bottom)Optional
- 3. Bottom Left Held (brightness_move_up_bottom)Optional
- 3. Bottom Left Released (brightness_stop_bottom)Optional
- 4. Bottom Right Pressed (off_bottom)Optional
- 4. Bottom Right Held (brightness_move_down_bottom)Optional
- 4. Bottom Right Released (brightness_stop_bottom)Optional
Information
- Forum views
- 3.4k
- Likes
- 1
- Checked
- Imports cleanly
- Category
- Remotes and buttons
- Discussion
- 0 replies on the forum