Screenshots from fxlt.
No screenshots yetAre you fxlt? Add your screenshots and they show here, at the top of the page.
What it does
Runs your own actions when someone uses an Inovelli VZM31-SN Blue Series switch through ZHA. You pick the switch, then set actions for the up paddle, down paddle and config button: press, hold, release, and two to five presses.
Written by vulpo.app from the blueprint file by fxlt. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
- Logbook
logbook 
Zigbee Home Automationzha
What you'll pick when you import it.
- Inovelli VZM31-SN
- Down paddle pressedOptional
- Up paddle pressedOptional
- Config button pressedOptional
- Down paddle heldOptional
- Up paddle heldOptional
- Config button heldOptional
- Down paddle releasedOptional
- Up paddle releasedOptional
- Config button releasedOptional
- Down paddle pressed twiceOptional
- Up paddle pressed twiceOptional
- Config button pressed twiceOptional
- Down paddle pressed three timesOptional
- Up paddle pressed three timesOptional
- Config button pressed three timesOptional
- Down paddle pressed four timesOptional
- Up paddle pressed four timesOptional
- Config button pressed four timesOptional
- Down paddle pressed five timesOptional
- Up paddle pressed five timesOptional
- Config button pressed five timesOptional
Information
- Forum views
- 7.3k
- Likes
- 8
- Checked
- Imports cleanly
- Category
- Remotes and buttons
- Discussion
- 21 replies on the forum
