Screenshots from MrBearPresident.
No screenshots yetAre you MrBearPresident? Add your screenshots and they show here, at the top of the page.
What it does
Runs your own actions when buttons on an IKEA STYRBAR remote are used, through ZHA or Zigbee2MQTT. You pick the remote, then set actions for single press, double press and hold on the on, off, left and right buttons, plus delay and loop limits.
Written by vulpo.app from the blueprint file by MrBearPresident. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
What you'll pick when you import it.
- (ZHA) RemoteOptional
- (Zigbee2MQTT) Remote NameOptional
- (Zigbee2MQTT) Base mqtt topicOptional
- On - Single press actionOptional
- Off - Single press actionOptional
- On - Hold actionOptional
- Off - Hold actionOptional
- On - Double press eventOptional
- On - Double press actionOptional
- Off - Double press eventOptional
- Off - Double press actionOptional
- Left - Single press actionOptional
- Right - Single press actionOptional
- Left - Hold actionOptional
- Right - Hold actionOptional
- Left - Double press eventOptional
- Left - Double press actionOptional
- Right - Double press eventOptional
- Right - Double press actionOptional
- Helper - Double press delayOptional
- Helper - Hold delayOptional
- Helper - Max number of loopsOptional
Information
- Forum views
- 2.8k
- Likes
- 3
- Checked
- Imports cleanly
- Category
- Remotes and buttons
- Discussion
- 3 replies on the forum