Screenshots from aledziko.
No screenshots yetAre you aledziko? Add your screenshots and they show here, at the top of the page.
What it does
Runs actions when an IKEA MYGGSPRAY motion sensor over Matter detects or stops detecting motion. You pick the sensor, optional active hours, a wait time, and an illuminance sensor with high and low thresholds. You can also set a battery sensor with a low level action.
Written by vulpo.app from the blueprint file by aledziko. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
- Binary sensor
binary_sensor - Group
group - Input boolean
input_boolean - Light
light 
Mattermatter- Sensor
sensor - Switch
switch
What you'll pick when you import it.
- Motion Sensor
- Enable Active Hours?Optional
- Active Start TimeOptional
- Active End TimeOptional
- Wait time (Motion)Optional
- Action: Motion DetectedOptional
- Action: Motion StoppedOptional
- (Optional) Safety DelayOptional
- (Optional) Monitored Light / SwitchOptional
- (Optional) Automation Latch HelperOptional
- (Optional) Illuminance SensorOptional
- (Optional) Motion Light CutoffOptional
- (Optional) Light High ThresholdOptional
- Action: Light HighOptional
- (Optional) Light Low ThresholdOptional
- Action: Light LowOptional
- (Optional) Battery SensorOptional
- (Optional) Battery Low LevelOptional
- Action: Battery LowOptional
Information
- Forum views
- 9.1k
- Likes
- 8
- Checked
- Imports cleanly
- Category
- Cameras
- Discussion
- 22 replies on the forum