Screenshots from Santobert.
No screenshots yetAre you Santobert? Add your screenshots and they show here, at the top of the page.
What it does
Runs your own actions from a Fibaro keyfob on Z-Wave. You pick the keyfob entity, then optionally set a press, hold and release action for each of the six buttons: square, circle, X, triangle, minus and plus. It works in press/hold mode only.
Written by vulpo.app from the blueprint file by Santobert. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
- Logbook
logbook - Z-Wave (legacy)
zwave
What you'll pick when you import it.
- Keyfob entity ID
- Square button press actionOptional
- Square button hold actionOptional
- Square button release (after holding) actionOptional
- Circle button press actionOptional
- Circle button hold actionOptional
- Circle button release (after holding) actionOptional
- X button press actionOptional
- X button hold actionOptional
- X button release (after holding) actionOptional
- Triangle button press actionOptional
- Triangle button hold actionOptional
- Triangle button release (after holding) actionOptional
- Minus button press actionOptional
- Minus button hold actionOptional
- Minus button release (after holding) actionOptional
- Plus button press actionOptional
- Plus button hold actionOptional
- Plus button release (after holding) actionOptional
Information
- Forum views
- 3.7k
- Likes
- 8
- Checked
- Imports cleanly
- Category
- Remotes and buttons
- Discussion
- 17 replies on the forum