Screenshots from Sam04.
No screenshots yetAre you Sam04? Add your screenshots and they show here, at the top of the page.
What it does
Turns a fan on and off based on whether someone is present and on the inside and outside temperatures. You pick the fan, the inside and outside temperature sensors and the presence sensor, then set an outside temperature, an inside threshold and a hysteresis value.
Written by vulpo.app from the blueprint file by Sam04. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
- Binary sensor
binary_sensor - Fan
fan - Sensor
sensor
What you'll pick when you import it.
- Fan
- Temperature Inside
- Temperature Outside
- Presence Sensor
- Outside temperature
- Inside temperature threshold
- Hysteresis
Information
- Forum views
- 7k
- Likes
- 4
- Checked
- Imports cleanly
- Needs Home Assistant
- 2024.8.0 or newer
- Category
- Climate
- Discussion
- 5 replies on the forum
