Screenshots from KipK.
No screenshots yetAre you KipK? Add your screenshots and they show here, at the top of the page.
What it does
Keeps an Aqara W100 climate controller and a main thermostat in step, so changes on either side carry over. You pick the thermostat and the W100, choose which heating, cooling, auto and fan modes apply, and set a sync delay. External temperature and humidity sensors can be shown on the W100.
Written by vulpo.app from the blueprint file by KipK. Something wrong, or are you the author? Get in touch
Set it up from your iPhone Vulpo's automation editor turns this blueprint's settings into a form, and shows each run as it happens.
Works with
- Climate
climate 
MQTTmqtt- Number
number - Sensor
sensor
What you'll pick when you import it.
- Main Thermostat
- Aqara W100 Climate Controller
- Heating SupportOptional
- Cooling SupportOptional
- Auto Mode SupportOptional
- Fan Mode SupportOptional
- Synchronization DelayOptional
- Enable External Data PublishingOptional
- External Temperature SensorOptional
- External Humidity SensorOptional
Information
- Forum views
- 5.6k
- Likes
- 7
- Checked
- Imports cleanly
- Category
- Climate
- Discussion
- 23 replies on the forum